Technical Data; General Safety - Belle Group 188-00010 Manuel De L'opérateur

Hydraulic Disc Cutter
Tool Physicals
Weight
Length (Without Blade)
Length (With Blade)
Width
Max. Blade Diameter
Arbor Diameter
Hydraulic Requirements
Type of System
Flow Rate
Maximum Pressure Range
Maximum Pressure Relied Setting
Filtration
Back Pressure (Max)
Hose Length (Max)
Couplings
Water Requirements for Wet Cutting
Operation
Speed @ 5 gpm
Speed @ 6 gpm
Speed @ 7 gpm
Speed @ 8 gpm
Cutting Depth
For your own personal protection and for the safety of those around you, please read and ensure you fully understand the following
safety information. It is the responsibility of the operator to ensure that he/she fully understands how to operate this equipment safely.
If you are unsure about the safe and correct use of the Disc Cutter & Floor Saw, consult your supervisor or Belle Group.
Improper maintenance can be hazardous. Read and Understand this section before you perform any
CAUTION
maintenance, service or repairs.
• Cordon off the work area and keep members of the public and unauthorized personnel at a safe distance.
• Personal Protective Equipment (PPE) must be worn by the operator whenever this equipment is being used (see Health & Safety).
• Make sure you know how to safely switch this machine OFF before you switch it ON in case you get into diffi culty.
• Never remove or tamper with any guards fi tted, they are there for your protection. Always check guards for condition and security,
if any are damaged or missing, DO NOT USE THE DISC CUTTER OR FLOOR SAW until the guard has been replaced or repaired.
• DO NOT operate the Saw when you are ill, feeling tired, or when under the infl uence of alcohol or drugs.
• Never operate the Saw in an explosive atmoshphere and/or near combustible material that could be ignited by a spark.
• Keep the Saw handles dry, clean and free of oil or fuel.
• Never exceed the fl ow and pressure rating of the Saw.
• DO NOT attempt to adjust the Saw during operation.
• Always shut off the hydraulic power sources before disconnecting the hoses or servicing the cutter.
• Always use blades that meet applicable safety code specifi cations. Read and comply with blade manufacturer's instructions and
safety precautions provided with the blade. Destroy any blade with cracks, chips, gouges, or loose or missing tips.
• Always hold the saw with both hands during operation. Use a fi rm grip ont he handles.
• Prior to cutting, plan your cuts to prevent pinching of the blade or personal injury caused by falling material.
• Never exceed the maximum fl ow and pressure rating of the saw which is 8 gpm at 2500 psi.
• Do not exceed either the maximum operating speed of 4100 fpm or the blade manufacturer's rated speed.
• Any slurry formed during wet cutting is very slick. Remove while still wet to prevent yourself or others from slipping while cutting.
Slurry, when dry is very hard to remove.
• Always shut off the hydraulic power and cooling water sources before disconnecting the hoses. Never remove fi ttings or compo-
nents when fl uid is hot.
• Always shut off hydraulic source & cooling water sources when equipment not in use.

Technical Data

2000-2500 psi

General Safety

5
Imperial
21lbs
27 In
32.2 In
5.5 In
14 In
1 In
Open Centre
5-8 gpm
2500 psi
10 Microns (Nominal)
500 psi
100ft
1/2" HTMA Flush Face
Use the fl ow and pressure
recommended by the blade
manufacturer.
2570 rpm
3080 rpm
3590 rpm
4100 rpm
5.25 In
GB
Metric
10 Kg
686mm
820mm
140mm
356mm
25mm
20-30 lpm
136-172 Bar
172 Bar
34 Bar
30m
132mm
GB