Preparation - Kohler K-14677 Guide D'installation Et D'entretien

3.

Preparation

Adapter (Supplied with Spout)
Adaptateur (fourni avec le bec)
Adaptador (incluido con el surtidor)
1/2" Nom.
Copper Tube
Tube en cuivre
Tubo de cobre
1/2" Nom.
Copper Cap
Capuchon en cuivre
Tapón de cobre
Provide an access panel for all installations.
Allow for access to the connection between the shower high-pressure hose and the
shower interlock hose.
For easiest installation, do not install the bath unit until all soldering (except
supplies) is complete. Then install the bath and connect the supplies.
If used, install the bath spout shank at this time according to the spout installation
instructions. If possible, do not install the finished trim until all other installations
and construction are completed.
For spouts with a supply tee: Solder in an adapter and a 1/2" copper tube. Cap
to close the extra port.
Install the valve bodies according to the valve body installation instructions.
Loosely secure the valve bodies.
Follow the handle installation instructions to temporarily assemble the handles to
adjust the valves to the proper height. Adjust the valve height before connecting
the lines to the diverter or supply.
NOTE: The cartridge assembly is easier to remove before the diverter is installed. You
can remove the assembly now or after the diverter installation.
Use a wrench to loosen the cartridge assembly from the diverter body. Continue to
unthread the assembly to remove.
Set the assembly aside. Protect the seals and O-rings from becoming dirty,
damaged, or misaligned.
Préparation
Prévoir un panneau d'accès pour toutes les installations.
Permettre un accès à la connexion entre le tuyau de haute pression de la douche
et le tuyau d'asservissement.
Pour une installation plus facile, ne pas installer la baignoire avant d'avoir tout
souder (excepté les alimentations). Puis installer la baignoire et connecter les
alimentations.
1138924-2-B
Spout Supply Tee
T d'alimentation du bec
T de suministro del surtidor
8 Kohler Co.