Commissioning; Maintenance; Releasing The Transmitter; Dimensional Drawings - Gossen MetraWatt Camille Bauer SINEAX V 604 Mode D'emploi

Of the programmable details listed in section «4. Brief
description», one parameter – the output signal – has to be
determined by PC programming as well as mechanical
setting on the transmitter:
... the output signal range by PC
... the type of output has to be set by DIP switch on the
instrument.
For the setting of the DIP switch, the main PCB must be
withdrawn from the transmitter housing (see Section "7.
Withdrawing and inserting the device") and setting the DIP
switches as shown in Table 7. The eight DIP switches are
located at the outer right on the conventional component
side of the PCB.
Table 7
DIP switches Type of
output signal
load-independent
ON
current
1 2 3 4 5 6 7 8
load-independent
ON
voltage
1 2 3 4 5 6 7 8

11. Commissioning

Switch on the measuring input and the power supply. The
green LED flashes for 5 seconds after switching on and then
lights continuously.
The power supply unit must be capable of supplying
a brief current surge when switching on. The trans-
mitter presents a low impedance at the instant of
switching which requires a current I
≥ 160 mA for the version with a power supply
... I
start
range of 24 – 60 V DC/AC
≥ 35 mA for the version with a power supply
... I
start
range of 85 – 230 V DC/AC

12. Maintenance

No maintenance is required.
of ...
start
or

13. Releasing the transmitter

Release the transmitter from a top-hat rail as shown in
Fig. 10.
ON ON
( (
Fig. 10

14. Dimensional drawings

+0,5
17,5
+0
Fig. 11. Transmitter clipped onto a top-hat rail (35 × 15 mm or
35 × 7.5 mm) acc. to EN 50 022.
14 6,5
12
+0,5
17,5
+0
Fig. 12. Transmitter with the screw hole brackets pulled out for
wall mounting.
146,5
145,5
27