Num'axes SL1008 Guide D'utilisation page 54

Setting the Programmable Selection Mode
Your camera can be programmed to operate either in PIR
Detection mode or Time Lapse/PIR mode. When changing the
settings, the switch is in the SET position then you have to slide
it to MANUAL.
•
MANUAL - This allows the user to define what settings
the camera will use.
Passive Infrared Mode
Setting the camera in PIR Mode
•
Slide the switch to the SET position from OFF.
•
The status display will show the camera current status.
•
Press the [M] button once to enter the Manual
programming mode, the word "PIR" or "TLS" will be
blinking.
•
Press the [UP] or [DN] button to select PIR mode.
•
Press [OK] to save your selection.
•
Press the [M] button to exit.
Time-Lapse/PIR Mode
54/80