Driver Installation; Hardware Installation - i-tec PCE2S Mode D'emploi

Quick Start / PCIe to 2S Adapter 2x Serial (PCE2S)
INTRODUCTION:
PCIe to 2S adapter is card to PCIe slot in PC type PCI express. After instala-
tion of drivers this adapter is as standard 2xCOM ports. This card offers output
RS232 type DB9 Male for asynchronous connection of I/O devices, e.g. external
modem, GSM modem, printer with serial port, barcode reader etc. Baud rate on
serial port enables using in applications in automatization, monitoring and con-
trol of industrial processes.
SPECIFICATION:
• Interface: PCI express specification 1.1
• Ports: 2x Serial RS232 type DB9 (Male)
• UART: Support UART types by 450 to 550 (fully programmable)
• FIFO receiver/transmitter works with data size up 256 byte
• Data rate on Serial port up to 230400bps
• Support Plug&Play and Hot Swap
• Operation system: Win 7/8/10 32+64bit, Linux, DOS
PACKAGE:
• 1x PCIe to 2S adapter
• 1x Panel with cables for 2xDB9 serial
• 2x Low Profile Backplate
• Manual

DRIVER INSTALLATION

(Note: Drivers are available here: www.i-tec.cz/en/)
For Windows 7/8/10 32_64bit
®
1. Don't insert the PCIe card into PCIe slot.
2. Download corresponding drivers and unpack (unzip) them to HDD from
www.i-tec.cz/en/.
3. Click on the "StnSetup.exe" button for the installation of drivers from a corre-
sponding directory for the OS and "Exit" to finish installation.
4. Shutdown the PC. Place the PCIe card into PCIe slot and then power on the
system.
5. Once the system gets booted the Windows will automatically start installing
the device driver software. If it is necessary, restart the PC.

HARDWARE INSTALLATION

(Warning: at first read instructions of driver installation)
Note: Connection of the COM connector- a red core in the cable from DB-9
belongs to the sign ∆ on the PCE card
EN
5