Altec Lansing inMotion iM3 Mode D'emploi page 6

Symptom Possible Problem
Crackling sound Bad connection.
from speakers.
A problem with your audio source.
Crackling sound Volume level in operating system is set too high.
from speakers
(when connected
to PC or laptop).
Sound is Volume level on inMotion iM3 system is set too high.
distorted.
Sound source is distorted.
Sound is Volume level in operating system is set too high.
distorted (when
connected to PC
or laptop).
Radio Too close to a radio tower.
interference.
Remote Control Low batteries.
doesn't work.
Remote Control is not pointed toward the inMotion
iM3 system's IR window.
Solution
Check connection if iPod is in the docking station. Check connection of the
3.5mm stereo cable. Make sure it is connected to "line-out," "audio-out,"
or the headphone jack on your sound card or other audio source — and NOT
"speaker-out."
Unplug the 3.5mm stereo cable from the audio source. Then plug it into the
headphone jack of an alternate source (e.g., Walkman, Discman or FM radio).
Check the operating system volume level and decrease if necessary.
Press the "–" button to decrease the volume.
WAV and .MID files are often of poor quality; therefore distortion and noise
are easily noticed with high-powered speakers. Try a different audio source
such as a music CD.
Check the operating system volume level and decrease if necessary.
Move your speakers to see if the interference goes away.
Replace batteries.
Point the Remote Control toward the IR window, within 15 feet of the unit.
4