Troubleshooting Guide; Understanding Sounds You May Hear - LG LFCS25663 Série Manuel De L'utilisateur

UNDERSTANDING SOUNDS YOU MAY HEAR

Your new refrigerator might produce certain noises that
your previous refrigerator did not. It is normal if you worry.
Most of the new sounds you will be hearing are actually
normal and expected. Hard surfaces like walls or floor
can increase sounds and make them sound louder than
they really are. The following list has a description of such
sounds along with their causes.
The thawing timer will make a "click" sound when such
timer will start and finish. Temperature controlling
device will also make a "click" sound at the beginning
and ending of the refrigerator cycle.
Problem
THE REFRIGERATOR
WON´T TURN ON
THE DISPLAY
SHOWS THE
WORD "OFF"
THE LIGHT WON'T
TURN ON

TROUBLESHOOTING GUIDE

Possible Causes
The plug is correctly positioned.
A fuse has gone bad or the circuit
presents failures.
The refrigerator is in the defrosting
cycle.
Refrigerator is in Demo Mode.
(Demonstration Mode)
Interior lights have malfunctioned.
You will hear a bell sound caused by the flow of the
refrigerant, water pipe or objects located on the superior
part of the refrigerator.
Your refrigerator is designed to work efficiently to
preserve your food at the desired temperature using
the least of energy. You will be able to hear a pulsing
sound coming from the ventilators and the evaporator.
The speed of the ventilator can speed up when you
open the refrigerator door.
After each cycle you will hear a dripping sound due to
the refrigerant liquid in your refrigerator.
Contraction and expansion of the inner walls can cause
a slight popping sound.
You will hear a dripping sound caused during the
thawing cycle.
During the defrosting cycle the water might cause a
dripping sound.
You can hear some tight air sound over the capacitor
caused by the fan.
Running water can be heard during the defrosting
cycle.
Due to its low energy consumption design of the
refrigerator; the fans will remain of, while the on-off
switch activated the internal light of bin.
Solutions
Firmly plug the cord into a live outlet with proper
voltage.
Replace the fuse or reset the circuit breaker.
Wait about 30 minutes for defrost cycle to end.
The Demonstration Mode disables the cooling
system; only the lamps and display work
normally.
To disable open refrigerator doors and then
press ICE PLUS
buttons at the same time for 5 seconds.
Interior lights are LED lightning, and repair
service must be performed by a qualified
technician.
and REFRIGERATOR