Charging Tips - Kenwood KSC-Y32 Mode D'emploi

ORIENTATION
* By connecting to a PC using a commercially available shielded USB data transfer cable
(USB 2.0 A Male to Micro B) and through installing an optional "KAS-12 BATTERY READER",
the record of the intelligent battery (battery pack equipped with a data terminal) can be monitored
during charging.
The USB driver is included with KAS-12.
You can also download the latest driver from URL. http://www2.jvckenwood.com/usb-com/
(This URL may change without notice.)
ATTENTION:
◆ Use a USB cable shorter than 3 m.
SPECIFICATIONS
AC Voltages
Dimensions (W x H x D) (charger only)
Weight (charger only)
ATTENTION:
◆ Check the rating label attached to the bottom of the charger for other important specifi cations.

CHARGING TIPS

• Using the transceiver while charging its battery pack will interfere with correct charging.
• If the operating time of a battery pack decreases although the battery pack is fully and correctly
charged, perform reconditioning if the Intelligent Battery (battery pack is equipped with a data
terminal). If the operating time of the battery pack still decreases, the battery pack life is over.
Replace the battery pack.
• The ambient temperature should be from 5°C to 40°C (41°F to 104°F) while charging is in progress.
When the ambient temperature is in the upper limits (close to 40°C (104°F)), the charging time may
become longer than normal.
• The charging times provided are obtained when a battery pack discharged to 1 V/cell x 6 (Ni-MH) or
3 V/cell x 2 (Li-ion) is charged at normal temperatures. This charging time varies depending on the
degree of discharge and the ambient charging temperature.
• Repeatedly recharging a fully charged battery pack, or almost fully charged pack, shortens its
operating time. To resolve this problem, use the pack until it is completely discharged,
1 V/cell x 6 then recharge the pack to full capacity (Ni-MH).
The battery life in charge/discharge cycles is approximately 300 to 500. However, overcharging and
•
excessive discharging shortens the battery pack life.
• When using this equipment near a radio, transceiver or television, you may experience interference
with reception.
Charging slot
Slide a battery pack or
a transceiver equipped
with a battery pack into
this slot.
LED indicator
Informs you of the
current charger status.
100 V - 240 V AC 50/ 60 Hz
160 mm x 90 mm x 58 mm / 6.30 x 3.54 x 2.28 in.
Approx. 210 g / 7.3 oz
PC (Micro USB) port *
The USB connector allows you
to directly connect to a computer
by using a commercially available
USB cable.
AC adapter jack
Plug in the supplied AC adapter
here.
3