Télécharger Imprimer la page

Star Manufacturing International ULTRA-MAX 824M Instructions D'installation Et D'opération page 6

Publicité

LEVELING UNIT
This griddle is supplied with 4 feet or floor stand legs which must be screwed into the body.
After the griddle is in its final position, adjust the legs to create 1/8 inch slant from back to front.
This will allow the grease to run into the grease gutter and provide the proper combustion air for
the burners. Adjusting the (4) feet which have an adjustment of 1-3/4" for accurate and perfect
line-up with other units.
CAUTION
DO NOT INSTALL WITHOUT ATTACHING FEET OR SUPPLIED STAND LEGS AND
SHELF - DO NOT REMOVE FEET.
Caster Kits: Casters can be used with floor
stand models or optional equipment stand.
For installation, carefully mark and cut off from
the bottom of each leg using a straight cutting
saw and de-burr the inside tube wall prior to
installing the caster. Cut leg should measure
19" tube length, not overall length. Casters add
about 6-1/4" of height to the unit. Be sure to
use approved strain relief means for protecting
gas line connection. If an appliance is equipped
with casters and is gas connected with a quick
connect coupling, all personnel must be aware
that there is a restraint on the appliance and if
disconnected for service or cleaning it must be
reconnected as originally installed prior to use.


Publicité

loading