Fan Only; Adjusting The Fan Speed; Night Mode / Energy Saving; High Power Mode - Technibel Climatisation MRAF98R5I Série Notice D'utilisation

NOTE
Use DRY operation when you want to reduce the humidity
●
in the room.
● Once the room temperature reaches the set level, the unit
repeats the cycle of turning on and off automatically.
During DRY operation, the fan speed is automatically set
●
(Remote control lamp
Dry operation is not possible if the indoor temperature is
●
10 °C or less.

FAN ONLY

If you want to make air circulate without any temperature
control, follow these steps:
1. Press the ON/OFF operation button and switch the air
conditioner ON.
2. Press MODE button until only the
appears on the display.

ADJUSTING THE FAN SPEED

AUTOMATIC
Simply set the FAN selector to the
microcomputer automatically controls the fan speed when
the AUTO mode is selected. When the air conditioner starts
operating, the difference between the room temperature
and the set temperature is detected by the microcomputer
which then automatically switches the fan speed to the
most suitable level.
WHEN DIFFERENCE BETWEEN
ROOM TEMPERATURE AND SET
TEMPERATURE IS
Cooling and 2 °C and over
dehumidifying Between 2 and 1 °C
modes: Below 1 °C
2 °C and over
Heating mode:
Below 2 °C
NOTE
The above mentioned data make reference to the
conditioner operating when the sensor on the remote control
unit is ON. (Refer to temperature sensor selector). If the
sensor on the indoor unit is being used then actual operation
will slightly differ from that described in the above tables.
The automatic speed is not available in FAN ONLY mode.
MANUAL
If you want to manually adjust speed just set the FAN selector
as desired.
High speed Med. speed
is ON) to prevent overcooling.
fan sign
position.A
FAN SPEED
High
Medium
Low
High
Medium
Low speed

NIGHT MODE / ENERGY SAVING

This mode enables you to save energy.
●
1. Set the MODE selector to cool, dry or heat.
2. Press the NIGHT button.
3. The mark appears on the display. Press the NIGHT
button again to release the NIGHT function.
What does the NIGHT mode mean?
When you select the NIGHT mode, the air conditioner will
modify automatically the set temperature after 60 minutes.
This enables you to save energy without sacrificing your
comfort.
OPERATING MODE
Heating
Cooling and Dehumidifying
NOTA
During the NIGHT mode the internal fan speed is
automatically lower and reduces the noise.
COOLING AND DEHUMIDIFYING
Function selection
Selezione funzione
Room temperature
Temperatura ambiente
1°C
1 h

HIGH POWER MODE

When this mode is active the internal fan speed is set
automatically and the air conditioner operates, for 15
minutes, at the maximum power. After 15 minutes from the
selection the symbol
mode is automatically switched off.
NOTE
During the high power operation the room temperature
could not correspond to the set temperature.
7
SET TEMPERATURE CHANGE
Lowered by 1 °C
Raised by 2 °C
TIME
TEMPO
HEATING
Function selection
Selezione funzione
Room temperature
Temperatura ambiente
2°C
1 h
on the display switch off and the
EG
TIME TEMPO