Special Functions; Demo Mode - Whirlpool ACM 800 Mode D'emploi

Control panel warnings.
Residual heat indicator.
The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot.
If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to keep a
dish warm or to melt butter.
When the cooking zone cools down, the display goes off.
Incorrect or missing pot indicator.
If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for your induction hob, the message "no pot" will
appear in the display (see figure at side). If no pot is detected within 60 seconds, the hob switches off.

Special functions

Some models have special functions:
Fast boil function (Booster)
This function, only present on some cooking zones, makes it possible to exploit the hob's maximum power (for example to bring water to the boil very quickly). To
activate the function, press the "+" button until "P" appears on the display. After 10 minutes' use of the booster function, the appliance automatically sets the zone to
level 9.
Automatic function
The function automatically sets the power level to maintain a light boil. Activate this function after bringing to the boil, pressing first of all the cooking zone button
followed by button .
Eco Booster
With the hob on and the cooking zone selected, press button
the boil and then keep it simmering, with reduced energy consumption compared to the normal booster function. The function is only provided for the two cooking
zones identified by the symbol

Demo Mode

This hob is equipped with a demo mode which allows you to interact with the control panel without activating the corresponding cooking zones. The activation and deactivation
procedure must be carried out within 60 seconds of the appliance being connected to the power supply in the home.
To activate the demo mode, hold the two external cooking zone selection buttons at the same time for at least 5 seconds: "dE" appears on the central display. You can now explore
the control panel functions. The Lock and Unlock function is active also in Demo Mode.
To deactivate Demo mode, repeat the procedure, remembering first of all to disconnect the hob from the mains and then reconnect it, carrying out the procedure within 60 seconds
of connection.
Activation/deactivation of the acoustic signal
To deactivate the acoustic signal, hold the " +" button and the most external selection button at the same time for at least three seconds. To reactivate the acoustic
signal, repeat the procedure. The activation and deactivation procedure must be carried out within 60 seconds of the appliance being connected to the power supply
in the home.
to activate the function. The hob automatically activates a cycle that allows you to bring water to
.
5 Sec
5 Sec
GB16