Before Switching On - Tecnolux MR47X82A+ Mode D'emploi

INSTALLATION
Location
When selecting a position for your Fridge you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 16 and 32 . Avoid
locating your Fridge near a heat source, egg, cooker, boiler or radiator. Also avoid direct sunlight
in outbuildings or sun lounges. If you are placing your Fridge in an out-building such as a garage
or annex ensure that the Fridge is placed above the damp course, otherwise condensation will
occur on the Fridge cabinet. Never place the Fridge in a wall recessed or into fitted cabinets or
furiture when your Fridge is working, the grille at the back may become hot and the sides warm.
It must therefore be installed so that the back of the Fridge has at least 9cm(31/2") of free space
and the sides have 2cm(3/4"). Do not drape the Fridge with any covering.
Leveling the Fridge
If the Fridge is not level, the door and magnetic seal alignment will be affected and may cause
you Fridge to work incorrectly. Once the Fridge is placed in its final location, adjust the leveling
feet at the front by turning them.
Cleaning before use
Wipe the inside of the Fridge with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing in the Fridge. The external parts of the Fridge can be cleaned with
wax polish. See page 12 for more details on cleaning.
Before plugging in YOU MUST
Check that you have a socket, which is compatible with the plug supplied with the Fridge. If not
see the section called ELECTRICAL INFORMATION on page 11.

Before switching on!

DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your Fridge
Before storing foods in your Fridge, turn the Fridge on and wait for 24 hours, to make sure it is
4