Disposal - Zipper Maschinen ZI-RMM94H 230V Manuel D'utilisation

Before disconnect the machine from the power supply and disconnect the air supply. Turn off the
compressed air supply and release by the filling the remaining pressure from the system before
disconnecting the machine at (24) from the compressed air supply.

Disposal

17 Troubleshooting
Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem!
Trouble
Machine does not start
Burn marks on the workpiece
Fence values different from
the set value
The finished size of the
machined workpiece is
incorrect for the cutting width
on rip fence
Sliding table at end positions
higher than machine table
Workpiece clamped while
advancing
Broken edges on the
workpiece
Arm running not smoothly
ZIPPER MASCHINEN GmbH
ZI-RMM94H29
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available. If you buy a new machine or an equivalent device from your
specialist retailer, he is obliged in certain countries to dispose of your old
machine properly.
 Emergency stop switch to
switch off
 switch or a phase is broken
 Overload protection is
triggered.
 Safety fuse is blown
 Open cover plate for saw
blades
 The blade is blunt
 Ruler incorrectly set
 Adjusted measurement scale
for the cutting width display
 Lower rollers set incorrectly
 dull blade
 Riving knife thickness does not
match the used blade
 The scoring saw is not on the
same line with the main saw
 Telescopic tube or track rollers
dirty
www.Zipper-Maschinen.at
W A R N I N G
Possible cause
TROUBLESHOOTING
Solution
 Turn the emergency OFF switch
to the right to unlock to
 Repair the defective circuit or
the faulty phase
 Wait until the engine cools
down
 Replace the fuse
 Cover plate close
 Replace the blade
 Adjust the ruler correctly
 Setting dimension scale:
workpiece on the rip fence,
measure the workpiece and the
measuring scale move so that
the measured average width is
shown at the edge of the ruler
 Adjust the lower rollers
 Replace with sharp blade
 Splitting wedge thickness must
be greater than or equal to
blade thickness.
 Set the scoring saw a new
 telescopic tube or track rollers
clean
 Check wipers
cut
29