Publicité
Les langues disponibles
Les langues disponibles
6. Protection
The LS700P has circuitry to prevent clipping, over current and over excursion. The circuitry does not
alter the frequency response as the level changes. At high levels the limiter will limit the gain of
the LS700P and hence if the user attempts to set the subwoofer level control at high levels the re-
sulting setting will be incorrect. The level control should be set while operating at low levels (under
10 watts). If the level control is set to high due to setting it at high operating levels the input circuit
will clip and the dynamics of the bass will be lost. This can happen without audible distortion since
the filters will filter out the distortion.
LS700P
POWER
SUBWOOFER
AMPLIFIER
Output
ONE SUBWOOFER, WITH MONO SYSTEM
LS700P
POWER
SUBWOOFER
AMPLIFIER
Left
Left
Right
Right
ONE SUBWOOFER, WITH STEREO SYSTEM
Note: The LS700P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our
E160 cabinets. The support tube can be adjusted up to it's full 5-foot 4-inch extension safely as long as the LS700P
LS700P Configuration Examples
FULL–RANGE
SPEAKER/s
FULL–RANGE
SPEAKERS
is not inclined mor than 10° (10-degrees).
WARNING: Larger or heavier cabinets shound not be used!
Left
Right
FULL–RANGE
SPEAKER
POWER
LS700P
AMPLIFIER
SUBWOOFER
TWO SUBWOOFERS PER SYSTEM
élite
PROCESSOR
LS700P
L
R
SUBWOOFER
MID/
SUB
MID/
SUB
INPUT
HI
OUT
INPUT
HI
OUT
Left
POWER
Right
AMPLIFIER
R
AMP IN
AMP OUT
L
ONE SUBWOOFER USING ÉLITE PROCESSOR
FULL–RANGE
SPEAKER
LS700P
SUBWOOFER
FULL–RANGE
SPEAKERS
Publicité
