Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS, USE AND MAINTENANCE HANDBOOK
GAS FRY-TOP 700 UNICO / 6 UNICO
1.
GENERAL INSTRUCTIONS
2.
2.1
2.2
Installation
2.3
2.4
3.
Table 1 (gas consumption)
Table 2 (UNICO burners)
Table 3 (6 UNICO burners)
Table 4 (UNICO and 6 UNICO SERIES)
4.
4.1
5.
5.1
5.2
5.3
5.4
Replacing the injector of the main burner
5.5
Adjusting the minimum
6.
6.1
6.2
6.3
6.4
6.5
7.
Read the instructions contained in this handbook carefully as they give important advice concerning safety of installation,
use and maintenance.
Keep this handbook for any further consultation by the various operators.
After having removed the packing, make sure the equipment is intact. In case of doubt, do not use the equipment and
contact professionally qualified staff.
Before connecting the equipment, make sure that the rating corresponds to that of the gas mains.
The equipment must only be used by staff trained in use of the same.
Before carrying out cleaning and maintenance, disconnect the equipment from the gas supply system.
Switch the equipment off in the case of a fault or malfunctioning. For any repairs only contact an authorised technical
service centre and request the use of original spare parts.
Failure to observe the above may jeopardise safety of the equipment.
Connection, installation of the system and appliances, ventilation and fumes extraction must be carried out according to
the manufacturer's instructions, by professionally specialised staff, in accordance with the standards.
This equipment must only be used for the purpose for which it was specifically designed.
Do not wash the equipment with direct, high pressure jets of water.
Do not obstruct the openings or vents for extraction or release of heat.
So as to avoid the risk of rust or chemical attack in general, the stainless steel surfaces have to be kept properly clean.
Clean the parts in stainless steel daily with warm, soapy water, then rinse thoroughly and dry carefully.
On no account should the stainless steel be cleaned with steel wool pads, brushes or scrapers in standard steel, in that
they could deposit ferrous particles which, by oxidising, cause rust spots. Stainless steel wool can, if necessary, be used
in the direction of the satin finish.
If you don't use the equipment long periods, close the gas valve and wipe all the steel surfaces vigorously with a cloth
moistened with Vaseline oil in order to apply a protective layer; also air the rooms periodically.
Before carrying out the connection, check on the technical data plate that the appliance has been tested and type-
approved for the type of gas available on the user's premises.
Should the type of gas indicated on the plate not be that available, follow the instructions in the paragraph "Conversion to
different type of gas".
The manufacturer of the appliance declines every responsability for possible mistake contained in this booklet imputable
to printing or transcription errors. It also reserves the right to bring changes to the product if retains useful or necessary
without jeopardizing the essential characteristics.
CONTENTS
1. GENERAL INSTRUCTIONS
6
Code 888670
Rev.00 05/2012
6
7
7
7
7
7
8
8
8
8
8
8
8
9
9
9
9
9
9
9
9
10
10
10
10
10
Publicité
Chapitres
Table des Matières
