Initial Start-Up; Important Notes; Rotary Speeds; Changing Speeds - Heiniger Evo 3 Mode D'emploi

3 Initial start-up

3.1 Important notes

• The voltage specified on the maker's plate and that of the local
power supply must match. The plant may only be connected to an
AC power supply.
• It is a compulsory that the operator has read the safety regulations.
• In the event that the plant is operated from a generator, the mains
supply voltage must not exceed that specified on the maker's rating
plate.

3.2 Rotary speeds

The three-speed portable shearing plant is specially designed for
professional use.
The lowest speed is ideal for inexperienced shearers and for shea-
ring under difficult conditions.
The medium speed setting is suitable for shearers with average shea-
ring skills and for running in new shearing handpieces.
The high speed setting is for experienced, professional shearers who
demand high shearing performance.
3.3 Changing the speeds
An authorised service point in compliance with the following instruc-
tions may only carry out changing the speed!
• Pull out the plug from the socket.
• Remove the cover by loosening the nine screws (Diag. 2, pos. a).
A plate bearing the speed specification is fitted beneath the cover.
See also Chapter 4.2, "Service" .
Diag. 2
The self-tensioning belt tensions the belt automatically.
• Push the belt by means of a slight movement so that the drive axis
turns into the new desired position (Diag. 2, pos. c). To ensure that
the belt is not damaged, do not use any auxiliary aids when chan-
ging speeds. Make sure that the belt is located in the grooves at the
same height on both axis.
• Re-secure the cover using the nine screws (Diag. 2, pos. a).
EVO Shearing Plant – Instruction Manual 9