Key To Symbols; Battery Safety; Battery Handling - Husqvarna BLi80 Manuel D'utilisation

Key to symbols

Translation of the original Swedish operating instruction.
WARNING! Incorrect or careless use of
a battery can turn it into a dangerous
tool that can cause serious or even
fatal injury. It is extremely important
that you read and understand the
contents of the operator's manual.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
This product is in accordance with
applicable EC directives.
Symbols on the product or its
packaging indicate that this product
cannot be handled as domestic
waste. This product must be
deposited at an appropriate
recycling facility.
Do not leave, store or use the
battery outdoors in the rain or in wet
conditions.

Battery safety

This section describes the battery and
battery charger safety for your battery product.
(1) to (8) refer to the figure on page 2.
Only use Husqvarna original batteries for Husqvarna
products and only charge them in an original battery
charger from Husqvarna. The batteries are software
encrypted.
Battery
The rechargeable Husqvarna batteries, BLi, are
exclusively used as a power supply for the relevant
Husqvarna cordless appliances. To avoid injury, the
battery must not be used as a power source for other
devices. (1)
• Do not dismantle, open or shred batteries.
• Do not expose cells or batteries to heat or fire. Avoid
storage in direct sunlight.
• Do not short-circuit a cell or battery. Do not store
batteries haphazardly in a box or drawer where they
may short-circuit each other or be short-circuited by
other metal objects.
• Do not remove a cell or battery from its original
packaging until required for use.
• Do not subject cells or batteries to mechanical shock.
• In the event of cell leaking, do not allow the liquid to
come in contact with the skin or eyes. If contact has

BATTERY HANDLING

•
•
•
•
•
•
•
•
•
•
•
Li-ion
•
•
•
•
Operation
The display shows the battery capacity and if there are
any problems with the battery. The battery capacity is
displayed for 5 seconds after the machine is switched off
or the battery indicator button is pressed. (8) The warning
symbol on the battery is lit when an error has occurred.
See fault codes. (6)
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are lit.
LED 1, LED 2 are lit.
LED 1 is lit.
LED 1 flashes
When all the LEDs are lit on the battery, it is fully charged.
(7)
been made, wash the affected area with copious
amounts of water and seek medical advice.
Do not use any charger other than that specifically
provided for use with the equipment.
Observe the plus (+) and minus (-) marks on the cell,
battery and equipment and ensure correct use.
Do not use any cell or battery which is not designed
for use with the equipment.
Do not mix cells of different manufacture, capacity,
size or type within a device.
Keep cells or batteries out of the reach of children.
Always purchase the correct cell or battery for the
equipment.
Keep cells or battery clean and dry.
Wipe the cell or battery terminals with a clean dry
cloth if they become dirty.
Secondary cells and batteries need to be charged
before use. Always use the correct charger and refer
to manufacturer's instruction or equipment manual for
proper charging instructions.
Do not leave a battery on prolonged charge when not
in use.
After extended periods of storage, it may be
necessary to charge and discharge the cells or
batteries several times to obtain maximum
performance.
Secondary cells or batteries give their best
performance when they are operated at normal room
temperature (20 °C ± 5 °C).
Retain the original product literature for future
reference.
Use only the cell or battery in the application for which
it was intended.
When possible, remove the battery from the
equipment when not in use.
Battery status
Fully charged (75-100%).
The battery is 50%-75%
charged.
The battery is 25%-50%
charged.
The battery is 0%-25%
charged.
The battery is empty.
Charge the battery.
–
English 3