Proper Use; Technical Data - Pentatech DF270K Mode D'emploi

GB
Operating instructions
1. Introduction
Read through these operating instructions fully and carefully and while doing
so fold out page 3 with the illustrations. The operating instructions belong to
this product and contain important points concerning bringing the appliance
into service and ist operation. Also read the operating instructions of the basic
set.Always pay attention to all safety instructions. Should you have any
questions or be unsure about operating the appliance ask a specialist. Keep
these instructions in a safe place and should the need arise pass them on to a
third party.

2. Proper use

The additional wireless observation camera consists of camera
the mains adaptor. The additional camera is an optional accessory for
Set or DVT30. It is to be used for the surveillance of rooms, entrance
hallways, driveways etc. through video pictures and sound. The video and
audio transmission is wireless using a frequency of 2.4 GHz.
The power for the DF270 K is supplied through the supplied mains adapter
connected to a 230VAC, 50Hz mains supply.
If there is sufficient light a colour picture will be transmitted. At low ambient
light levels the integrated Infrared LEDs are automatically switched on. In this
case the immediate area (max. 10 m) will be illuminated and the video picture
switches to black and white mode for improved light sensitivity. The picture
quality is optimised for day and night opereation by an internal mechanical
filter change. If the surveillance is specifically required in a dark environment,
then additional lighting should be installed.
Up to four wireless cameras DF270
to three wireless cameras DF270 and the outdoor station
monitor DVT30M. The camera channels can be manually selected or
automatically displayed in sequence if the scan mode is selected. The camera
pictures can also be observed simultaneously in quad-split screen mode. The
wireless transmission is digital and on constantly changing frequencies
(frequency hopping) which are synchronised between the camera and the
monitor. Only the receiver which has been "paired" with the camera can receive
the synchronised signals. This security feature prevents access of the camera
signal by third parties.
The camera is weatherproof (Protection class IP66) and can be used not only
indoors but also for mounting outside. Wherever possible it should be protected
from direct rainfall. The monitor and both mains adapters are for indoor use
only and must be protected from moisture.
The set is for use in private households. A video surveillance system does not
replace your duty of care or supervision. Observe the regulations concerning
video surveillance in commercial and public areas.
Any other use or modification of the device is not authorised. No liability will be
accepted for consequential damages or for damages caused by improper use or
incorrect operation. No liability will be accepted for consequential damages
caused by any function or by malfunction. Unless any liability is specifically
required by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the machine,
are excluded.
12 - GB
K can be used with one monitor DF270M. Up
K can be used with one
This appliance is not intended to be used by people (including children) with
restricted physical, sensory or mental capacities, or a lack of experience and/or
knowledge, unless they are supervised by, or receive instructions how to use the
appliance from a person responsible for their safety.
3. Package contents
!
DF270 K camera with connection cable to mains adapter
!
Antenna
!
Mains adapter 5VDC
!
Camera bracket with screws and plugs
!
User manual

4. Technical data

Camera DF270K
DF270 K and
Operating Voltage
DF270
Current consumption
Channels
Picture sensor
Viewing angle
Light sensitivity
Infrared filter
Illumination
Illumination distance
Microphone
Protection class
Dimensions without antenna (mm) 123 x Ø 60
Operating temperature
Mains Adapter
Operating Voltage
Output
5. Features and Equipment
1 Daylightsensor
2 Power LED
3 Lens
4 Infrared LEDs
5 Connection-LED
6 Antenna connection
7 Fixing hole for bracket
8 Microphone
9 Pairing button
10 Mains adapter connection
11 Triangular nut
12 Wing screw
13 Bracket
14 Antenna
15 Plugs
16 Mains adapter
17 Screws
(s. page 3)
"
5 V DC (mains adapter)
550 mA
4
1/4" CMOS
approx. 63° horizontal
1 Lux (w/o IR-LEDs)
automatic change
25 Infrared LEDs
max. 10 m
built in
IP 66
- 10° C to + 40° C
230 V ~ 50 Hz
"
5 V , 1,0 A
(s. page 3)