General Points - Hayward 7015046 Guide De L'utilisateur

GENERAL POINTS

This remote control is used to control the color changes of the LED spotlights from a distance.
The controller is installed in series on the spotlight power supply.
It is designed to be connected to a TBTS 230V/12V transformer designed for lighting under-water spotlights and installed
in a separate box or inside the swimming pool's electrical box.
A radio remote control is used to send instructions remotely to the controller which immediately sends them to the
projectors connected to it. These instructions are transmitted via a combination of micro-breaks in the power supply which
are interpreted by the spotlights. This patented procedure has the advantage of being simple and resistant to disturbance,
and makes it possible to communicate with spotlights several tens of metres away.
Remote control
Swimming Remote control
emitter
pool electrical receiver
box
LED spotlight
Main power Lighting
supply transformer
to the box secondary circuit
230V  12V 
Only Hayward RGB spotlights are compatible with this remote control and can be controlled. Check that your spotlights
are compatible before installing this remote control.
INSTALLATION
The remote control must be connected to the lighting transformer's secondary circuit.
Only compatible spotlights must be connected to this transformer. The total power of the connected spotlights must under
no circumstances exceed 120W.
Receiver
for the
remote control
2 1 3
230V 
TBTS transformer
230V  / 12V 
12 V 
Spotlight 1 Spotlight 2
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 4 of 7 Lights Rev. D