Temperature Adjustment - BaBylissPro BAB2171TTE Mode D'emploi

ENGlISH
PRoGRAMMABlE
CuRlING IRoNS
Available in three sizes (ø 16, ø 19
and ø 25 mm), this curling iron
heats up very quickly and is ready
to use in just a moment.
The temperature selector lets you
set the exact temperature desired
(30 settings).
For fine hair, use a lower
temperature to get the best re-
sults and to respect the hair's inte-
grity perfectly.
For thick, wavy or hard to curl hair,
use a higher temperature for best
results.
FEATuRES
• Titanium tourmaline coating on
the heating barrel
ø 16mm - BAB2171TTE
ø 19mm - BAB2172TTE
ø 25mm - BAB2173TTE
• On/Off switch
- on indicator light
• Automatic switch off
• 30 temperature settings (130°C
to 200°C) - linear adjustment
• Stay-cool tip
• Swivel cord
• Built-in metal stand

TEMPERATuRE ADJuSTMENT

See table.
This curling iron also has a built-in
stand that allows you to put him
down during use and in this way
it protects your surfaces. There is
also a stay-cool tip to make styling
hair easier and safer.
INSTRuCTIoNS FoR uSE
• Plug the unit in and press on the
'i' button. The iron will begin to
heat up. Set the temperature
using the selector. The red indi-
cator light will flash for a while
until the unit reaches the desired
temperature. When the light is
fixed, the unit is ready to use.
• Divide dry or damp hair into
equal sections and comb before
curling. Press on the clamp lever,
place the iron halfway along the
section of hair and spread the
hair evenly between the clamp
and the barrel. Pull the iron gent-
ly to the end of the hair. To pre-
vent crimps, make sure the hair is
properly coiled under the clamp,
in the direction of the curl. Place
the clamp on top of the section
to curl the hair under. To curl the
hair out, place the clamp under-
neath the section.
• Coil the hair up to where you
want the curls to start, being ca-
reful not to touch the scalp with
the barrels. Keep the iron in place
for 5 to 8 seconds. For tighter,
bouncier curls, work with only a
little hair at a time. For looser, sof-
ter curls, work with more hair.
• To remove the iron, press on the
clamp lever and pull the iron out.
Wait until the hair has cooled
before brushing or combing to
allow the curls to 'set'. For best
results, we recommend using Ba-
Byliss Pro styling products.
5