Assembly - Ryobi Tek4 DURASHOT RP4200 Manuel D'utilisation

UNPACKING
This product has been shipped completely assembled.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
wARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Digital Camera
Download cable (USB to mini USB)
1GB SD Card
Lanyard
Soft Case
Operator's Manual
wARNING:
Always remove battery pack from the product when you
are assembling parts, making adjustments, cleaning, or
when not in use.
wARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
TO INSTALL / REMOVE BATTERy PACK
See Figure 2, page 12.
To install the battery pack:
 Unscrew the battery cap.
NOTE: Do not remove the gasket inside the cap.
 Insert the battery pack in the direction shown. Make sure
the raised rib on the battery pack aligns with the groove
in the camera.

ASSEMBLy

wARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
wARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
wARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
OPERATION
 Place the cap over the battery pack and push until
the cap meets the threads at the end of the battery
compartment.
 Screw the cap on securely.
To remove the battery pack:
 Power the camera off. Unscrew the cap. The battery pack
will disconnect and be easy to remove.
 Do not attempt to use this product if the battery cap is
not securely closed.
wATERPROOF RATING
The IP67 waterproof rating denotes that the product is totally
protected against dust and against the effect of immersion
up to 1 m.
Do not use this camera for diving or any other prolonged
underwater use. If the camera is exposed to rain or immersed
in water, wipe it dry as soon as possible.
The waterproof rating applies only when the the battery cap
and the USB/SD card slot door are securely closed.
6