JUISSEN Slow Juicer Manuel De L'utilisateur page 8

3. Insert the squeezing screw into the strainer
and turn until it drops into position (Fig 5).
Fig. 5
4. Assemble the hopper onto the bowl (Fig 6).
Align the small arrow on the hopper with the red
dot on the bowl.
14
EN
Fig. 6
Twist the hopper so that the plastic tab with the
arrow on it points to the closed sign on the base
(Fig 7).
Note: The small arrow from part 4 will no longer
be aligned with the red dot once the hopper is
locked to the close position (Fig 7).
→
Fig. 7
2.3 Operating instructions
Important:
• Do not operate the juicer with wet hands as it
may cause an electric shock.
• Do not operate the juicer prior to imputing jui-
cing materials.
• Do not operate for more than 15 minutes at one
time.
1. Plug in the juicer.
2. Place a container below the juicer outlet and a
container below the pulp outlet.
3. The juicer power button (located at the upside
of the handle) has 3 positions.
A. "ON": This starts the motor and jui-
cing process.
B. "OFF": Is the central position of the
button. It switches off the appliance.
C. "REV": Is reverse. Only use this func-
tion when something is stuck in the juicer and it
nedds to be unclogged.
4. Insert the material you wish to juicer into the ho-
pper.
• Ensure pieces are not larger than 4cm for optimal
juicer extraction.
• Remove any large pips or seeds
• Always pre-wash food before juicing.
• Do not overstuff the hopper or force food in. Insert
food slowly to allow juicer time to work. The pusher
is only be used if food becomes stuck (Fig 8).
Fig. 8
5. Switch the power button to "ON".
• Insert food slowly to allow juicer time to work.
• Do not overstuff the hopper or force food in.
The pusher is only to be used if food becomes
stuck.
6. When you are finished switch the power but-
ton to "OFF".
If the machine becomes clogged and inoperable:
1. Turn the machine off and press the reverse bu-
tton for a few seconds then try operating again.
Note: The reverse button works with a 'pulse'
motion.
2. If the reverse button does not work turn off the
machine and switch off at the power point. Di-
sassemble the unit to dislodge any material then
reassemble as per the instructions and try again.
How to disassemble and clean the unit:
1. Switch off the unit.
2. Twist the bowl and hopper as one piece to
the right so that the arrow on the hopper moves
away from the close position. Lift off (Fig. 9).
Fig. 9
3. Disassemble the parts in the order show by the
diagram (Fig 10).
→ →
Fig. 10
4. Use the brush to clean all of these parts tho-
roughly in warm soapy water then dry thorou-
ghly.
5. Use a damp cloth to wipe down the base of
the unit.
3. CLEAN TIPS
• Periodically remove the silicone brushes from
the spinning brush and clean thoroughly before
reassembling.
• Thoroughly clean immediately after each use to
minimize staining.
• Pull out the rubber stopper on the base of the
bowl to clean bowl effectively. Always ensure
the rubber stopper is re-inserted prior to juicing
otherwise it may cause a leak.
• Do not use harsh abrasives or chemicals to
clean the juicer.
• Do not clean in the dish washer.
4. TECNIC SPECIFICATIONS
• Input voltage: AC 220-240V
• Frequency: 50Hz
• Power: 150W
• Speed: 65rpm
• Max. Operation time: 30 minutes
15
EN