Connecting The Printer; Switching On The Printer - TallyGenicom 7265 Manuel D'utilisation

Quick start-up

Connecting the printer

Switching on the printer

Make sure that the printer is set to the correct voltage (e.g.
230 V in Europe, 120 V in the U.S.A.). To do this, check the
plate above the power inlet at the rear of the printer.
If the setting is incorrect, set the coloured switch at the rear
of the printer to the correct position, using a pointed object
(e.g. screwdriver, ball pen or tweezers).
Make sure that the printer is switched off before set-
STOP
ting the correct voltage; otherwise severe damage
may be caused.
Never switch on the printer if the voltage setting is
incorrect, since this may cause severe damage to
the printer.
Make sure that the printer and the computer are switched off,
and connect the printer to the computer with the data cable
(interface cable).
Connect the power cable to the power inlet of the printer.
Connect the power cable plug to a mains socket.
The power switch for switching on the printer is located at
the bottom left at the front of the printer when viewed from
the front.
Installation
7