Sony FW-100BU40J Manuel D'installation page 12

FW-32BU30J / 32BZ30J only
1
Detaching the Table-Top Stand
from the LCD Display.
To detach the Table-Top Stand from the LCD
Display, remove the screws.
Note
• Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on
the LCD Display.
• Be sure the LCD Display is vertical before turning
on. To avoid uneven picture uniformity do not
power on the LCD Display with the LCD panel facing
down.
• Place the LCD Display with its screen facing down
on a level and stable surface covered with a thick
and soft cloth when removing the Table-Top Stand
from the LCD Display to prevent damaging the
surface of the LCD display.
2
Remove the screws from the
rear of the LCD Display.
12
(US)
Soft cloth
3
Attach the Wall-Mount Bracket
(not supplied) using the screws
(not supplied).
Screw (not
supplied)
Wall-Mount
Bracket (not
supplied)
Note
• If using an electric screwdriver, set the torque at
approximately 1.5 N·m {15 kgf·cm}.
Soft cloth