Work Sharp WS2000 Mode D'emploi page 7

12
STEP 
Place tool in sharpening port under the
tool hold-down, on the right side of align-
ment fence.
STEP 
Slide fence against left edge of tool in port
and hand tighten alignment fence knob.
STEP 
Keeping the tool flat on the sharpening
port diamond surface; "plunge and pull"
the tool in and out of the sharpening port
to sharpen the bevel.
Plunge
www.worksharptools.com
Pull
Only contact the wheel during "plunge" for
one-half to one second.
Repeat "plunge and pull" sharpening in
the sharpening port until a consistent
finish, or desired sharpness is achieved.
For best surface finish and sharpness, flip
wheel so fine abrasive is face down and
repeat step 5.
Edge-Vision
TM
Underside Port—
For small carving tools,
screwdrivers, and general
grinding
Edge-Vision Port
TM
☛
Tip
Use a permanent marker to color
the edge of your tool to be sharp-
ened.
Step 1
Mount the Edge-Vision slotted wheel
TM
and turn unit around so you are facing the
underside port on backside of tool.
Step 2
Slowly bring tool into the Edge-Vision
underside port under the wheel.
www.worksharptools.com
Step 
Look down through the spinning Edge-
Vision wheel to see the cutting edge.
TM
Sharpen the tool to your desired shape and
sharpness.
☛
Tip
Use a shop light to shine through
the top of the Edge-Vision™ wheel
to improve your view of the tool
being sharpened.
Topside Freehand
Sharpening
use optional)—For putty knives,
scrapers, axes, hatchets and
other flat-blade tools
Step 1
Mount the Edge-Vision™ wheel onto the
unit.
Step 2
Lay blade face onto the right side of grind-
ing wheel.
Step 
Pull blade towards you keeping blade face
flat on the grinding surface.
TM
Step 
Raise tool or handle to create or re-sharp-
en a beveled edge if desired.
Pull slowly
towards you
Step 
Repeat this step on the other side of the
blade tool being sharpened. Continue until
desired finish or sharpness is achieved.
General Purpose
(top tool rest
Grinding
Larger work pieces are best ground using
the top side of the Edge-Vision
You can use either slotted or solid abrasive
media for these tasks. Smaller work pieces
are best ground using the Edge-Vision
wheel with slotted abrasives and the
Underside Port. This enables you to take
advantage of the Edge-Vision's unique
ability to let you see through the wheel
and actually see the material surface as
you grind it.
1
Use side-to-side motion
TM wheel.
TM