Philips pronto RFX9400/37B Guide De Démarrage page 8

RFX9400 Starter's Guide
To configure the Network Extender:
1
Connect the Extender to the PC with the
configuration cable (this is the crossed
Ethernet cable enclosed).
2
Set the switches correctly:
Note • If there is already an Extender with ID 0, set the Extender ID switch to an ID that is not
• Make sure the same Extender ID is used on the Extender and the Pronto Control Panel.
3
Plug in the Extender's power adapter.
The Extender will start up. After startup, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
4
Open the browser.
5
Type the IP address of the Extender (printed on the bottom of the Extender) in the
address bar of the browser.
The Configuration Tool opens in the browser.
6
Follow the onscreen instructions and make sure you have the following information at
hand:
• If the Extender will be connected wirelessly to the Pronto Network: the SSID and
encryption settings.
• If the Extender will be operating with a fixed IP address: the IP address, netmask and
default gateway.
Tip To ensure optimal performance, use a dedicated network for all Pronto communication.
This makes the Pronto Network independent from other network traffic and changes in
network settings.
7
Disconnect the Extender from the PC.
8
Connect the Extender to the Pronto Network:
• For a wired connection, connect the Extender to the router by means of a straight Ethernet
cable.
• For a wireless connection, you do not need to connect any more cables.
9
Set the switches correctly:
The Extender will restart. After startup,
• In a wired network connection, the Power and Ethernet LEDs are green and the Busy LED
blinks green when it's processing a code or a macro from the Control Panel.
• In a wireless network connection, the Power and WiFi LEDs are green and the Busy LED
blinks green when it's processing a code or a macro from the Control Panel.
5
Stand-alone/Network
Configuration switch
Extender ID
used yet.
Stand-alone/Network
Configuration switch
Extender ID
Extender Configuration
cable
Network
2
0
Network
1
0