Specifications - Philips pronto RFX9400/37B Guide De Démarrage

3
Open the ProntoEdit Professional on the PC.
4
In the Tools menu, select Extender Discovery.
The Extender Discovery tool appears, with a list of all the detected Extenders in the Pronto
Network.
5
Select the Extender that you want to configure and click on the Configure button.
The Configuration Tool opens in the browser.
6
Select Firmware Update in the left navigation pane.
The Firmware Update page opens.
7
Follow the onscreen instructions.

Specifications

The specifications and design of this product are subject to change without notice.
General
Modes
Dimensions
Operating temperature
Infrared (IR)
Radio Frequency (RF)
Dual IR emitters
Mono mini-jack cables
Power adapter
Pronto Wireless Extender Starter's Guide
© Copyright 2006 Royal Philips Electronics, Interleuvenlaan 72 - 74, 3000 Leuven (Belgium)
Remarks:
All rights are reserved. Reproduction in whole or in part is prohibited without prior consent of the copyright owner.
Royal Philips Electronics is not liable for omissions or for technical or editorial errors in this manual or for damages
directly or indirectly resulting from the use of the Pronto Wireless Extender.
The information in this Starter's Guide may be subject to change without prior notice.
All brand or product names are trademarks or registered trademarks of their respective companies or organizations.
Dark grey ABS housing with poly carbonate front plate
802.11 b/g compliant RF technology
4 LED indications for Power, WiFi, Network and Busy
Up to 16 extenders and 16 control panels in a system (for all modes)
4 addressable outputs for IR emitters
Ethernet RJ45 connection
Rotatable RF antenna
Positioning: freestanding or mounted in any position
Stand-alone (wireless): Similar to WiFi ad-hoc mode; no access point and
router required
Network (wireless): Similar to WiFi infrastructure mode; used in a system with
a router and access point
Network (wired via Ethernet): used in a system with a router and access point
3,98 x 6,18 x 1,3 inch (101,2 x 157 x 33,5 mm)
32°F to 122°F (0°C to 50°C)
IR frequency range: 25kHz-1MHz (including DC/flash codes)
IR power out: 2 levels
802.11g at 2.4 GHz with additional proprietary protocol
Number of IR emitters: up to 4 (2x2), emitters wired in series
0.13 inch (3.5 mm) mono mini-jack
Cable length: 9 ft (2.7 meters)
0.13 inch (3.5 mm) mono mini-jack
Cable length: 5 ft (1.5 meters)
100V-240 VAC / 50-60 Hz Power adapter (5V DC/2A output, UL-CE approved)
RFX9400 Starter's Guide
10