Product Description - Wallbox COPPER SB Guide D'installation

Connector Recommendations
• Always check the charging cable and the contacts for damage and contamination before use.
• Never use a damaged charging cable, the vehicle plug, or the infrastructure electrical outlet to charge.
• Never use contacts that are dirty or wet.
• Only connect the connector to vehicle plug and infrastructure electrical outlets that are protected
against water, moisture and liquids.
• After stopping the charging process, the vehicle connector and the equipment plug can be
disconnected. Never use force to disconnect the vehicle connector from the inlet or the equipment
plug power outlet. Such dangerous activity can cause serious injuries or even death.
• Depending on the charging station and the electric vehicle, the time to complete the charging process
and the duration of unlocking may vary.
• Some vehicles can be started with the charging cable connected. Be sure to unplug before driving off.
• Do not use the charging cable with an extension cable or an adapter.
• If the connector emits smoke or begins to melt, never touch the charging cable. If possible, stop the
charging process. In any event, disconnect the power supply from the Wallbox device.
• Keep the charging cable out of the reach of children.
• Be careful with the connector, do not step on it or on the cable.
• The cable should NOT be tightened under ANY CIRCUMSTANCES while connected to the vehicle.
Important information for the correct disposal of the product in accordance with Directive 2012/19/EC.
At the end of its useful life, the product will not be disposed of as urban waste. It must be taken to a
collection center for special and differentiated waste or to a distributor that provides this service.

Product Description

Introduction
Wallbox Copper SB is adapted for commercial and semi public use. With the introduction of a universal
socket, the charger is suitable for both Type 1 and Type 2 vehicle connectors. Access control is managed
through RFID.
The Copper SB is an intelligent device that is always connected to the myWallbox charging management
platform. As a result, multiple users can be monitored and available power can be distributed amongst
various chargers.
5