Spark Arrester; Exhaust Muffler; Important - Maruyama H23DF Manuel D'utilisation

3
3 mm allen WrenCH
SuPPlIed In TOOl KIT

SPARK ARRESTER

Maintenance Interval: The spark arrester should be
inspected and cleaned after every 25 hours of use.
Replace the screen if it cannot be thoroughly cleaned or if it
is damage.
Maintenance: With the engine at ambient (room)
temperature. Remove the two socket head screws holding
the tail and spark arrester to the muffler. Remove and
clean the tail, gasket, and spark arrester with a safety
solvent and a stiff brush. If any part cannot be thoroughly
cleaned it must be replaced. Reinstall the spark arrester
and tail onto the muffler, then reinstall and tighten the two
socket head screws.

EXHAUST MUFFLER

Maintenance Interval: The muffler should be inspected and cleaned after each 100 hours of use.
Maintenance: Remove the engine cover (See Cylinder Cooling Fins). Remove the spark arrester
(See Spark Arrester maintenance), and clean the muffler with a stiff brush. Reinstall the spark
arrester and onto muffler, then reinstall and tighten the two socket head screws. Reinstall the
cylinder cover then tighten the knob. Reinstall the tail pipe and cover.
IMPORTANT: Do not use solvent for cleaning inside of muffler due to the catalytic
converter in muffler. Be careful not to allow any dirt or debris to fall into the exhaust port,
as this can cause engine damage.
English
KnOb
CylInder COVer
SoCket
head
SCreW
｜ 21 ｜
SPark
arreSter
tail