DeWalt DXCM024-0345 Guide D'utilisation page 7

2) Never connect to an air source that is greater than 300 PSI.
3) Inspect the air hose before each use to make sure there are
no leaks.
4) Do not wrap the hose around any parts of the body.
COMPRESSOR HOOK-UP
The hose reel includes a 3/8" x 4' lead-in hose that is attached to
the hose reel for hooking up the hose reel to your air source. Thread
and connect the open end into your air source. Attach air tool or
accessory to the air line outlet of the air hose on the hose reel.
OPERATION
Check the operation of the reel by slowly pulling out the hose. You
will hear a clicking noise.
LOCKING HOSE REEL
Pull out the hose slowly until the desire length of hose is reached,
allow it to retract after hearing a series of clicks.
UNLOCKING HOSE REEL
Pull out the hose slowly until the the clicking noise stops, allow it to
retract until the ball stop rests against the hose guide. DO NOT LET
GO OF THE HOSE!
WARNING: Risk of Injury. Do not let go of the hose when
retracting.
WARNING: Always disconnect air tool or accessory attached to
the hose reel from air supply before making any adjustments and
changing accessories.
ADJUSTING RECOIL TENSION
Occasional spring adjustment may be necessary when:
The spring has relaxed over time.
The hose has been replaced.
Large temperature changes have occurred.
CAUTION: Only adjust the spring when the hose is fully
rewound. Do not overtighten the spring.
1. Remove the cover (L) on the right
side of the hose reel by squeez-
ing the sides and pulling out the
bottom first.
2 Pull out the crank handle (M).
3. Turn the crank (N) clockwise to
increase tension, counterclock-
wise to reduce tension.
4. Turn the crank 5 times in the
desired direction. Check the
spring tension by pulling a short
length of hose and letting it
rewind.
5. Repeat if necessary.
6. Add or reduce tension until there
is JUST ENOUGH tension to fully rewind the hose. Push in the
crank handle to lock in place.
WARNING: Risk of Injury. Do not let go of the hose when
retracting.
7. Attach the cover back on the hose reel.
HOSE REPLACEMENT
1. Remove the covers (L) from both sides of the hose reel.
2. Disconnect the air supply from the hose reel.
3. Remove the 2 screws (O) that holds the front cover (P) in place.
4. Remove the front cover.
7