Specifications - Pioneer PDK-TS10 Mode D'emploi

Preventing Equipment from Falling Over
Using a wall for stabilization
1
Attaching falling prevention bolts (hooks) to
the Plasma Display.
2
Using strong cords or chains to firmly
stabilize it appropriately and firmly to a
wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right
sides.
Note
Use hooks, ropes, chains, and fittings
that are available on the market.
Recommended hook:
Nominal diameter M8
Length 12 to 15 mm (1/2 to 5/8 inch)
1
Hook
2
Cord or chain
Fitting

Specifications

External dimensions 566 (W) x 491 (H) x 325 (D) mm (22-5/16 (W) x 19-5/16 (H) x 12-25/32 (D) in.)
Weight 4.1 kg (9.0 lbs)
• The above specifications and exterior may be modified without prior notice to improve the product.
6
En
• A table or an area of the floor with adequate strength
should always be used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
• When installing the Plasma Display, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as
earthquakes, or of accidents.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks, chains and other fittings that you
12 to 15mm
use to secure the Plasma Display to prevent it from
(1/2 to 5/8 inch)
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks, chains and other
fittings after first inspecting the surface carefully to
determine its thickness and composition and after
consulting a professional installer if necessary.
Caution