Attaching The Plasma Display - Pioneer PDK-TS10 Mode D'emploi

Attaching the Plasma Display

Caution
The weight of a 50 inch Plasma Display is about 40 kg (88 lbs),
that of a 43 inch model is about 30 kg (66 lbs), they have no
depth, and are unstable. Therefore, at least two people must
assemble and install them.
Note
Insert the bolts in the holes vertically and do not tighten
them with more force than necessary.
Place a sheet or protective cover to protect the display from
scratches or damage.
Assemble only with the Plasma Display lying flat on a table
or similar surface.
Move the stand so that the stand screw holes and the nuts
that connect the main display line up correctly.
1
With the Plasma Display lying flat, insert
and secure the two Installation bolts 2 (M8
x 20 mm: black) in the holes "a" located in
center of the Plasma Display housing.
At this point, tighten these bolts 2 only until the threads
are no longer visible when viewed from the side (you will
be unable to attach the display if the bolts are screwed in
completely).
Installation
2
bolt
Plasma Display
housing
Plasma Display
Sheet
4
En
7 Regarding the stand pipe screw holes when the
Table: Stand pipe screw holes when the stand is used as a
desktop stand
Plasma Display model
43 inch display model
50 inch display model
2
Stop screwing
down the bolt
3
when the threads
are no longer
visible.
2
Installation bolt
(M8 x 20 mm: black)
Holes "a"
(holes in center
4
of Plasma
Display)
stand is used as a desktop stand
Screw holes used with stand orientation
B
A
B ´
A ´
As shown in the above figure, hook the
stand pipe holes (either pipe A or B) onto
the screw heads of the installation bolts 2,
then slide the stand upwards to the main
Plasma Display until it engages the installa-
tion bolts 2 (once put together with the
display, the stand will slides no more than
19 mm (3/4 inch)).
Pass the installation bolts 3 (M8 x 40 mm:
black) through the stand pipes and tighten
the installation bolts firmly with the
accessory hexagonal wrench (The holes
should be used in the proper combinations,
A–A' and B–B').
Tighten the installation bolts 2 firmly with
the accessory hexagonal wrench.
Table top stand
A, A'
B, B'
B
A
B ´
A ´
3
Installation bolts
(M8 x 40 mm: black) (Step 3)
Slide the stand
(Step 2)