Carrier KJR-120G1/TFBG-E Manuel D'utilisation page 9

3. INSTALLATION METHOD
Connect the female joint of wires group from the adapter board with the male joint of
connective wires group. Then connect the other side of adapter board with the display
board. (See Fig.3-3(B))
Please connect the other side of connective wires group with the male joint of
wires group leads from wire controller. (See Fig.3-3(B))
4.Remove the upper part of wire controller
Insert a slot screwdriver into the slots in the lower
part of the wire controller (2 places), and remove
the upper part of the wire controller. (Fig.3-4)
NOTICE
The PCB is mounted in the upper part of the wire
controller. Be careful not to damage the board
with the slot screwdriver.
5. Fasten the back plate of the wire controller
For exposed mounting, fasten the back plate on the wall with the 3 screws (M4×20)
and plugs. (Fig.3-5)
Screws (M4×20)
Back plate
6
Slots
Fig 3-4
Fig 3-5
G B