Installing And Connecting The Unit - Pioneer SBX-B70 Guide Rapide

Installing and connecting the unit

Before connecting the unit or changing the connections, be sure to turn off the power and disconnect the power cord from the outlet.
Also, make sure you have finished connecting all cables before connecting the power cord to the wall outlet.
If you are placing the unit directly under a TV,
only place a TV of 40 kg or less within the
allowable placement area.
660 mm
Dotted range : Possible placement area
CAUTION
• Do not place a TV stand on top that is larger
than the possible placement area.
• Do not install the unit in an unstable place
such as on an unsteady stand or tilted
surface. The unit may fall or tip over, resulting
in injury.
• The unit is not magnetically shielded and
so should be used away from a cathode
ray tube (CRT) TV or monitor. Also, do not
place devices that are easily influenced by
magnetism (magnetic cards, watches, video
tapes, etc.) near the unit.
• Do not attach this unit to the wall or ceiling. It
may fall off and cause injury.
1. Place the unit.
CAUTION
• There are subwoofers located on the bottom
of the unit. Make sure that there is nothing
between the unit and the surface it is being
placed on it.
Subwoofer
• Place the unit so that it does not extend out
over the TV rack, shelf etc.
2. Wire the unit.
In order to make the wiring process as easy as
possible, complete all wiring prior to placing the
TV on top of the unit.
310 mm
Analog cable
(commercially
available)
FM wire antenna
(included)
If your TV does
not have a digital
terminal, connect it to
the analog terminal.
Digital audio pin cable
(commercially available)
Connecting using LAN cable
Internet
Router
LAN cable
(commercially
available)
Computer 1
Note
• Some connected devices (TV and set
top box etc.) have settings for the digital
audio output. For details, see the operating
instructions for the specific playback device.
Using external antennas
To improve FM reception and sound quality
One-touch PAL
connector
Optical digital audio
cable (included)
Remove the protection cap at
the end and then connect the
cable while paying attention to
the orientation of the connector.
If you will not use
the cable for your
TV connection, you
can use it to connect
another audio device.
BD/DVD
Modem
LAN
3 2 1 WAN
Computer 2
75 Ω coaxial cable
3. Place the TV on top of the unit, and
then wire the TV and other devices.
4. Place the TV in its final position.
CAUTION
• Place the TV in the center of the unit.
• Place the TV so that its stand does not stick
out over the unit.
• Refer to the operating instructions for your
TV for methods to prevent the TV from
tipping over or falling. Do not attach any
parts intended to prevent the TV from tipping
over or falling (such as belts etc.) to this unit.
Doing so may cause damage to the unit, or
result in fire or electric shock. Doing so may
also mean the TV can tip over or fall, and
being damaged or causing injury.
• Pioneer is not responsible for any accidents
or damage that result from improper
installation/mounting, incorrect use,
modification, disaster, etc.
5. Connect the power cord.
Note
• Set audio output from the built-in speakers of
the TV to OFF. If this cannot be set, set the
TV volume to the minimum level.
3
En