Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Towing hitch
Manufacturer: WESTFALIA-AUTOMOTIVE GmbH
Approval no. as per Guideline 94/20/EC:
Class: A50-X
Technical data:
Area of application:
General information:
The vehicle manufacturer's specifications regarding trailer load and nose weight are deci-
sive for driving, and the values specified for the towing hitch must not be exceeded.
The towing hitch serves for towing trailers fitted with ball couplings and for use with load carriers
approved for attachment to the towing hitch. Any use other than that specified is prohibited. Driving
with a trailer must be adapted to the road conditions. The vehicle's handling is affected when a trailer
is being towed. Follow the vehicle manufacturer's instructions.
The fixing points specified as standard must be observed.
National guidelines concerning official approval of auxiliaries must be observed.
These installation and operating instructions must be enclosed with the vehicle papers.
Installation instructions:
The towing hitch is a safety component and must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch is prohibited, and would lead to cancellation of
design certification.
Remove insulating compound and underseal from vehicle (if present) in the area of the mat-
ing surfaces of the towing hitch. Seal any bare bodywork and bores with anti-corrosive paint.
Operating instructions:
Again tighten all securing bolts of the towing hitch after approx. 1000 trailer km, observing speci-
fied tightening torques.
The towing hitch must be kept clean and greased. However, if a stabilisation device, e.g.
Westfalia "SSK", is used, the towing hitch must be free from grease. Follow the instructions in
the relevant operating instructions.
As soon as the towing hitch diameter is 49.0 mm or less at any point, it must no longer be used
for safety reasons.
After the towing hitch is fitted, the empty weight of the vehicle increases by 3,5 kg.
Installation Instructions:
Bolt the CBB to the rear cross member of the vehicle or to the towing bracket with four bolts (M
10) of the property class 10.9, washers and nuts (M 10) of the property class 10.
Tightening torque:
Without electrical set
Model:
Maximum D-value:
Maximum nose weight: 150 kg
Vehicles fitted with rear-end frame cross member or towbars
with a hole pattern of 56 x 83 mm.
for M 10 = 55 Nm + 10 %
Westfalia order no.: 329 062
e13 00-0585
329 062
23,5 kN
GB
Subject to alteration.
9
Publicité
Table des Matières
