Attaching The Antenna; Attaching The Supplied Microphone Stand Attachment Pole/Grip - Sony AN-01 Mode D'emploi

d Microphone stand attachment pole/
grip
With the PF1/2 screw at the bottom, this
antenna can be attached to a microphone
stand.
The grip also allows hand-held operation.
For details on how to attach this to the anttena, see
"Attaching the Supplied Microphone Stand
Attachment Pole/Grip" on page 20.
e Gain selector
Switches the antenna booster gain.
REMOTE: The gain switches
automatically according to the supplied
power voltage as follows:
• When 9 V DC is supplied: 10 dB
• When 12 V DC is supplied: 18 dB
18dB: 18 dB gain regardless of the supplied
power voltage
10dB: 10 dB gain regardless of the supplied
power voltage
0dB: 0 dB gain regardless of the supplied
power voltage
Note
Be sure to supply power to this antenna
even when the gain selector is set to "0dB".
When no power is supplied, no signal is
output from the RF output/DC power input
connector.
f RF output/DC power input
connector (BNC-R)
Connect to the antenna input connector of
the receiver (tuner, tuner base unit, or
antenna divider, etc.) to output the signal
amplified with the booster. The power is
supplied to the booster through this
connector.
20

Attaching the Antenna

Attaching the
Antenna
Attaching the Supplied
Microphone Stand
Attachment Pole/Grip
Bolt
Microphone stand
attachment pole/
grip
To prevent the antenna from coming
off the adjusted angle, turn the knob
clockwise firmly.
Antenna
Knob
Cover
Washer