Krüger & Matz DISCOVERY KM0523 Mode D'emploi page 9

Owner's manual
3. Start playing music from your microSD card.
Notes:
• The speaker supports only FAT32 cards.
• All tracks/folders will be played in alphabetical order.
nFc
1. Make sure the speaker is turned on.
2. Enable NFC function on the external device you are going to connect to.
3. Bring the external device close to the NFC area of the speaker. The devices will connect
automatically.
charging
1. Connect the USB charging cord to the micro
USB charging port of the speaker and insert the
other end into a port in a computer or other USB
charging device.
2. Lights in the chart below indicate the speaker's
remaining charge level:
Notes:
• please be sure the battery has been charged
fully before first use.
• Charging continues even if the speaker is turned off.
• If Bluetooth connection process is not completed within 10 minutes, the speaker will
turn off to save battery.
• A speaker battery indicator will be displayed when connected to iOS devices.
Operation
Bluetooth mode
Bluetooth pairing
Bluetooth connection established
AUX mode
MicroSD mode
100% battery
SPeciFicationS
60% battery
• Ip67 rating
• Output power: 2x 4 W
30% battery
• Impedance: 2 Ω
• Frequency response: 60 Hz~18 kHz
• THd: ≤ 0,5%
Low battery
• S/N ratio: ≥95 dB
• Speaker diameter: 40 mm
LED Status
Blue Led is on
Blue & Red Led flash alternately
Blue Led flashes slowly
Green LED is on
Yellow LED is on
9