Id Mode; Setting The Id Number - Canon VC-C50i Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 82

ID Mode

When multiple VC-C50i/VC-C50iR cameras are connected and installed, all the cameras in
range of the wireless controller simultaneously perform the operations specified. In this
situation, the cameras can be operated individually by assigning separate ID numbers to each
camera beforehand and then specifying the desired ID number from the wireless controller.
This is referred to as ID mode operation.

Setting the ID Number

Use the procedure below to assign an ID number (1 to 9) to each camera (VC-C50i/
VC-C50iR). If you do not want to assign an ID number to a camera, select [0] for that camera.
Assigning the same ID number to multiple cameras allows you to control those cameras
simultaneously.
BRIGHT
ZOOM
T
W
HOME
SET/OK
CANCEL
1
2
3
AF
4
5
6
MF
7
8
9
0
ON SCREEN
Fn
ID
MENU
1. Switch the power on to the cameras to which you
want to assign the same ID number. Switch the power
to the other connected cameras off.
Switch the power to a camera off by unplugging the AC adapter
connected to the camera (→ P.18). Even if you turn the power
off, the ID number will not be cleared.
2. Press the m button on the wireless controller to
display the MAIN MENU screen.
3. Select REMOTE CONTROLLER ID in the SET MENU
and set the ID number.
Use the 5 and 8 buttons to move the cursor up and down,
use the s or 6 button to confirm the selected setting and
proceed to the next level, and use the cor 4 button to move
back to the previous level without confirming the selected
setting. Use the 5 and 8 buttons to change values.
MA I N
MENU
SET MENU
D I SP
LAY
MENU
CA E
M
RA
MENU
NEXT SET
BACK CANCEL
4. When you have set the ID number, press the m
button or c button to exit the settings screens.
5. Repeat Steps 1 to 4 until ID numbers are set for all the
cameras.
SET MENU
RS - 232C
S
ETT I NGS . .
REMO
TE C
O
NTR
O
LLE
R
I D
0
C
O
MM
AN
D
VC
- C4
MOD
E
RESTORE DEFAULT
NEXT SET
BACK CANCEL
SET MENU
RS - 232C
S
ETT I NGS . .
REMO
TE C
O
NTR
O
LLE
R
I D
0
C
O
MM
AN
D
VC
- C4
MOD
E
RESTORE DEFAULT
NEXT SET
BACK CANCEL
SET MENU
REMO
TE C
O
NTR
O
LLE
R
I D
5
SET
SET
CANCEL
CANCEL
35

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vc-c50ir

Table des Matières