Rs-232C Settings - Canon VC-C50i Mode D'emploi

Camera Settings

RS-232C Settings

These settings are used for controlling the VC-C50i/VC-C50iR from a PC or other device. The
DATA 8 BIT and NON PARITY settings are fixed, and the menu is used to check them only.
DATA 8 BIT and NON PARITY are to be read only.
MA I N MENU
SET MENU
D I SP LAY MENU
CA E M RA MENU
NEXT SET BACK CANCEL
● For information on items other than the RS-232C SETTINGS item on the SET
MEMO
34
SET MENU
RS - 232C S ETT I NGS . .
REMO TE C O NTR O LLE
C O MM AN D V C
RESTORE DEFAULT
NEXT SET BACK CANCEL
MENU, see below.
(1) See page 35 for information on the REMOTE CONTROLLER ID setting.
(2) COMMAND is set when using the VC-C50i/VC-C50iR in Canon
Communication Camera VC-C3 mode (→ P.33).
(3) To restore the default values for the settings (→ P.40), select [SET] in the
RESTORE DEFAULT setting.
RS - 232C SE
BAUD R ATE
R I D 0 STOP B I T
- C4 MOD E DA TA 8 B I T
NON PAR I TY
NEXT SET BACK CANCEL
RS - 232C SE
BAUD R ATE
STOP B I T
DA TA 8 B I T
NON PAR I TY
NEXT SET BACK CANCEL
TT I NGS RS - 232C
9 6 0 0 BAUD R ATE
1
R AD E O LY N
R AD E O LY N
SET SET CANCEL
TT I NGS RS - 232C
9 6 0 0
1 STOP B I T
R AD E O LY N
R AD E O LY N
SET SET CANCEL
SE TT I NGS
4 8 0 0
9 6 0 0
1 4 4 0 0
1 9 2 0 0
CANCEL
SE TT I NGS
1
2
CANCEL