Publicité
Les langues disponibles
Les langues disponibles
User Manual
05
A
06
07
08
B
B
B
Removing the voice and data cover
Use a flathead screwdriveras a lever by placing
it between the voice and data cover and the
profile joint, as shown in diagram 03.
Connecting the data cables
Thread the V/D cables through the bottom part.
Place the RJ45 connectors in the cover and
connect
them,
as shown
Place the cover on the rail with the connectors
and collect any excess cable. For data cables
with a connector, a female I/O connector can
be inserted in the board.
.
Connecting the power supply
Connect the power cable to the GST 18 connector
incorporated at the end of rail B. Finally, put the
top cover back on.
Installing pdc with electric sockets only
You will see the base where you are going to
place it. Mark and use a drill to make the
necessary holes. Then, insert the rawlplugs and
screw the base to the floor, as shown in diagram
07.
Connecting the power supply
Connect the power cable to the GST 18
connector incorporated at the end of rail B. If it
has a regulated power supply and a normal
power supply, there will be two different coloured
GST connectors:
Red: Regulated, Black: Normal
For any queries related to the product, contact:
oficinatecnica@ib-connect.com
05-06
in det ail A.
Publicité
