Publicité
Les langues disponibles
Les langues disponibles
User Manual
05
Detailed view of the rear of the direct access
06
07
08
INSTALLATION CUBO RAISED ANCHOR
Use a Phillips head screwdriver to tighten the
A
screws holding the side anchors.
This time, the entry to the connectors is direct
with I/O connectors.
B
Connect power to the V/D: insert the cable into
direct opening B and connect to the RJ-45,
connect the other cable to the V/D plate A.
INSTALLATION CUBO SUPPORT 2
Important: Maximum rank 40mm
Place the product properly on the edge of the
table for installing. Pic 7.
Once the support is seated, turning the lower
screws counter-clockwise for fixing on desk.
The support is fully installed.
For any questions about the product
Get in touch with:
export@ib-connect.com
05 - 06
Publicité
