Installation - Dometic DTW12 Mode D'emploi

Installation

a vertical loop in the sanitation hose between the tank outlet and pump inlet that extends above the
holding tank .
2. Insert 38 mm ID duckbill valve in open end of pump body, and tighten valve nipple into pump body
with counter-clockwise motion (fig .
3 . In the four mounting feet locations on pump base (fig .
eter fasteners with 19 mm (0 .75 in .) maximum diameter washer to fasten pump to surface .
4. Apply small amount of liquid dishwashing detergent or Dometic hose lubricant (not supplied with
pump) around ends of pump inlet and discharge fittings and inside ends of 38 mm ID sanitation hose
that will attach to these fittings .
5 . Slip two hose clamps (not supplied) over each end of hose that attaches to pump . Push hose ends
onto pump fittings and position the clamps screws so that they are 180° apart from each other .
Tighten hose clamps to pump fittings (fig .
6 . With electrical power off, make proper wiring connections according to wiring diagram (fig .
2) . With pump switch in "off" position, if applicable, turn on electrical power .
Key to discharge pump wiring
Ref. Description
A Discharge pump
B V DC ground
C 12 or 24 V DC
D Black
6.2 Replacing macerator discharge pump
In discharge hose line from pump to seacock (if applicable) or overboard discharge fitting that mea-
sures 25 mm (1.0 in.) ID, install the reducing adapter (fig. 12, page 2) as close to the seacock fitting
as possible (no more than 1 m (3.3 ft.) from the seacock). Use liquid dishwashing detergent or Dometic
hose lubricant (not supplied) and properly sized hose clamps to connect the hose ends to the reducing
adapter (as described in Section 6 .1, step 4 and 5) .
Caution – Flooding Hazard!
If the toilet, holding tank or any components are connected to any through-hull fittings, prop-
erly installed seacocks must be installed in all piping connected to the through-hull fittings .
Seacocks must be easily accessible to all users of the system . All valves must be full-bore
valves and of marine (corrosion resistant) quality. Screw-to-close gate valves are not recom-
mended. Failure to do so can result in flooding, which can cause the loss of life and property.
Caution – Flooding Hazard!
Some marine practices and/or standards require the installation of a properly positioned
ventilated (vented) loop in the discharge piping to prevent back-siphonage of seawater
into the holding tank . It is up to the system installer and boat owner to select appropriate
means of preventing backflow into the holding tank.
6
, page 2) .
4
4
, page 2) .
5
(fig . 3 , page 2)
Ref.
Notes:
1. Use 14 gauge or larger diameter standard copper wire.
2 . Max . discharge pump circuit breaker or fuse rating: 20 amps
1
Dometic Waste Discharge Pump
1, page 2), use 6 mm (#12) minimum diam-
Description
E Red
F Power switch (on / off)
3 , page