Makita XRU07 Manuel D'instruction page 10

Hex wrench storage
015399
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Correct handling of tool
Correct posture
WARNING:
Always position the tool on your right-hand
•
side. Correct positioning of the tool allows for
maximum control and will reduce the risk of
serious personal injury caused by kickback.
Be extremely careful to maintain control of the
•
tool at all times. Do not allow the tool to be
deflected toward you or anyone in the work
vicinity. Failure to keep control of the tool could
result in serious injury to the bystander and the
operator.
015394
MAINTENANCE
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
attempting to
maintenance on the tool. Failure to switch off
and remove the battery cartridge may result in
serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
1. Hex wrench
1
perform inspection
Replacing the nylon cord
WARNING:
Use nylon cord with diameter specified in
•
"SPECIFICATIONS" only. Never use heavier
line, metal wire, rope or the like. Use
recommended nylon cord only, otherwise it may
cause damage to the tool and result in serious
personal injury.
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
015395
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
013823
Cut a nylon line in 3 m (10 ft). Fold the cutting line in two
halves, leave one of half longer 80-100 mm (3 - 4
inches) than another.
or
015396
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2
channels provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for right hand direction indicated by
RH.
10
1. 80 - 100 mm
1