nedis SPYCCL10CSR Mode D'emploi page 6

- When the switch is set to on and the red indicator is off, then
the camera is in stand-by mode.
- When the device is running out of memory the red indicator
will remain on and it is not possible to record any further.
Time and Alarm Settings of the Digital Clock
Time set
1. Press and hold the mode button for a few seconds until the
hours starts to flash. Use the + and – button to adjust the
hour.
2. Press the mode button again to set the minutes with the +
and – button.
3. Press the mode button again to set the year with the + and
– button.
4. Press the mode button when ready, the year stops flashing.
5. Press the shift button to return to the time.
6. Press the – button to set 12 or 24 hour system.
Alarm set
1. Press the shift button to enter alarm setting (ALM indication
appears in the display).
2. Press and hold the mode button to set the hour with the +
and – button.
3. Press the mode button again to set the minutes with the +
and – button.
4. Press the mode button and select with the + and – button
for the alarm music sound.
5. Press the shift button to save the alarm setting.
6. Press the – button to select the following options:
Alarm activated
Activate repeat alarm every 5 minutes up to a
maximum of 6 times
6
ENGLISH