Cleaning And Storage; Troubleshooting - easymaxx SF-1516 Mode D'emploi

5. To increase the level of heating, also move the switch for heating level II (6) to
position I.
6. To switch off the device, move all switches to position O.
7. Remove the mains plug from the plug socket after use.

Cleaning and Storage

PLEASE NOTE!
■ Pull the mains plug out of the socket and allow the device to cool down completely
before doing any cleaning!
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
• Dust down the device if necessary or wipe it down with a damp cloth if necessary.
Then wipe it dry with a dry cloth.
• When not in use, the device should be stored in a clean, dry place which is protected
from dust and is not accessible to children and animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work.
The fuse in the fuse
box is triggered.
Heating level I does
not work.
17
Possible cause
The mains plug is not inserted
correctly in the socket.
The socket is defective.
No mains voltage is present.
Too many devices connected
to the same circuit.
No error can be identifi ed.
The fi re lighting switch (8) has
not been moved to position I.
The dial (5) has not been
activated.
Fix
Correct the fi t of the mains
plug.
Try another
socket.
Check the fuse of the mains
connection.
Reduce the number of devic-
es in the circuit.
Contact our customer service
department.
Heating level I only works if
the light has been switched
on.
The dial must be turned in the
+ direction for the device to
start to heat up.
EN