Jumbo M1E-270A/10.8 Traduction Des Instructions D'origine page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Remove the battery from the device.Pressing the release buttons on both
side of battery, meanwhile take it out as arrow direction in (Fig. 6)
2. Insert the battery into the charger as show in (Fig. 6)
3. Connect the charger to the powersupply. (Fig. 6)
4. After a sufficent charging time( about 3-5hours, LED on charger lights up
green),disconnect the charger from the power supply
NOTE: It is normal for the battery and charger to become warm (but not hot)
during charging process. If the battery does not charge properly, check to
make sure the electrical outlet is „live".
Notes on charger:
• LED on charger lights up red: Battery is charging
• LED on charger lights up green: Charging completed
Self-discharge of batteries! Remove the battery from the
charger once it is fully charged.
72
Fig. 6
General instructions:
Regarding the battery, in order to maintain the long service life of the batte-
ry, always follow the instructions below:
• The hedge trimmer is automatically switched off when the battery voltage
is low. The
battery must then be recharged before the trimmer can be used again.
• Always recharge the lithium-ion battery prior to any prolonged period of
non-use, i.e. before
storing the hedge trimmer.
• The charging time is around 3-5 hours for battery that is completely empty.
• The lithium-ion rechargeable battery can be charged at any charge level
and charging can be interrupted at any time without damaging the battery
(no memory effect).
OPERATING INSTRUCTIONS
Any use, which is not expressly permitted in the manual, may result in
damage to the machine and place the user in serious danger. Please
carefully read the restrictions in the safety instructions.
Warning! Personal injury and damage! Keep your hands and feet away
from the cutting tool, especially when the products are switched on!
Before each use, check for damaged/worn parts, especially, Check the blade
for proper alignment.
STARTING AND STOPPING
STARTING:
Press and hold the safetylock-off(3) and the ON/OFF switch (4)
Note: The hedge trimmer will work when safety switch and switch trigger
are activated at the same time. If one of them is released, then the blade will
stop running.
STOPPING:
Release the ON/OFF switch (4)and the safetylock-off(3)
73
GB

Publicité

Table des Matières
loading

Table des Matières