Jumbo M1E-270A/10.8 Traduction Des Instructions D'origine page 36

Noise/Vibration Information
Measured sound values determined according to EN 60745-2-15.
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 60745-
2-15: The vibration emission level given in this information sheet has been
measured in accordance with a standardized test given in EN 60745-2-15
and may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the
tool. However if the tool is used for different applications, with different ac-
cessories or poorly maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into ac-
count the times when the tool is switched off or when it is running but not
actually doing the job. This may significantly reduce the exposure level over
the total working period.
Identify additional safety measures to protect the operator from the effects
of vibration such as: maintain the tool and the accessories, keep the hands
warm, organisation of work patterns.
ASSEMBLE
Warning! Before assembly, make sure that the tool is switched off and
remove the battery.
Fitting the hand guard(Fig. 1/Item 2)
Attach the hand guard (Fig. 1/Item 2) on the hedge trimmer, and fasten the
hand guardwith the 2 screws (Fig. 1/Item 8) as shown in Fig. 2
70
Remove the blade sheath from the blade. (Fig. 3)
Note: Wearing gloves to remove the blade sheath to avoid injury is recom-
mended.
Installing the battery (Fig. 4)
Push the battery pack into the main hand-
lein the directionof the arrow as shown in
Fig. 4, and make sure the battery is locked on
handle reliably.
Remove the battery (Fig. 5)
Remove the battery from the device.
Pressing the release buttons on both side
of battery, meanwhile take it out as arrow
direction in Fig. 5
Charge the battery (Fig. 6)
Fig. 2
Attention! Only use charger in dry places, away from moisture and
heat sources. Before first use, the battery needs to be charged for
about 3-5 hours. Use only the original charger.
Fig. 3
Fig. 4
Fig. 5
71
GB