Stopping Your Dishwasher; Connecting Your Portable Dishwasher; Connecting The Faucet Adapter - Whirlpool 400 Série Guide D'utilisation Et D'entretien

4. Add detergent and check the rinse aid dispenser. Add rinse
aid if needed. (See "Using Your Dishwasher.")
5. Push door firmly closed. The door latches automatically. Run
hot water at the sink where you will connect dishwasher until
water is hot. (See "Dishwasher Efficiency Tips.") Turn off the
water and hook the dishwasher to the faucet. (See
"Connecting Your Dishwasher.") Turn on the hot water.
6. Press the desired cycle and option selections. (See "Using
Your Dishwasher.") Turn the Cycle Control knob to the desired
cycle to start.

Stopping Your Dishwasher

You can stop your dishwasher anytime during a cycle.
1. Open the door slightly.
2. Wait for the spraying action to stop. Then open the door all
the way, if needed.
3. Close the door to continue the cycle.
OR
1. Turn the Cycle Control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control knob to OFF.
CONNECTING YOUR
PORTABLE DISHWASHER

Connecting the Faucet Adapter

NOTE: A special adapter must be installed on the faucet before
the dishwasher can be connected. Complete Installation
Instructions and the adapter are packed with your dishwasher.
(See the Installation Instructions).
When moving your dishwasher make sure the door is latched.
Hold the dishwasher at the top front corners.
8
Preparing the faucet
1. Remove the screen holder or aerator, screen, and washer
from the end of the faucet.
2. Use the faucet adapter kit that came with your portable
dishwasher to modify the faucet where the dishwasher will be
used.
1. Washer
2. Screen
3. Screen holder or aerator
NOTE: Remove and save the washer, screen, and screen holder
or aerator for future use.
Connecting the faucet adapter to faucets with
external threads
Insert the two screens and then the thin washer from the faucet
adapter kit into the faucet adapter. Attach the adapter onto the
end of the faucet.
1. Thin washer
2. Screens
3. Faucet adapter
NOTE: Do not use the thick washer.
Connecting the faucet adapter to faucets with
internal threads
Insert the 2 screens, the thin washer, and then the thick washer
from the faucet adapter kit into the faucet adapter. Attach the
adapter onto the end of the faucet.
1. Thick washer
2. Thin washer
3. Screens
4. Faucet adapter
NOTE: Use both washers.