Feed Button - Seiko Epson TM-P60 Manuel D'utilisation

English
How to Set Up the Network
Preparation
Printing a Status Sheet
Make sure the printer is turned off and the roll paper cover is closed properly.
Power on the printer and then open the roll paper cover. Hold down the FEED
button until the printer beeps (about 2 seconds). Close the roll paper cover. The
printer prints the parameters for the printer. You can check all setting values
necessary (SSID, Network mode, IP address, Subnet mask, Gateway address) for
the network connection.
Connection
Set the setting of the host PC and AP to match the network setting that you have
confirmed with the status sheet.
Note:
The AP mentioned above applies only to the printer if it is in the InfraStructure mode (you
can check it with the status sheet).
You can check whether the connection to the printer has been correctly done by
inputting the ping command through the command prompt.
Example: Ping 192.168.192.168
Note:
Although the example shows the address 192.168.192.168, use whatever IP address is
reported on the status sheet.
Because the default IP addresses for all the wireless printers are the same, you
should power on and configure only one printer at a time.
Resetting the Printer to Factory Defaults
Open the roll paper cover. Turn on the printer's power while pressing down the
FEED button. Press the FEED button 6 times. Close the roll paper cover. The printer
prints the procedure for resetting. Follow the procedure.
Host Operating System
®
Windows XP and 2000 are the recommended host PC operating systems because
they have built-in TCP/IP support.
Setup
There are two methods for the setup. For details, see the TM-P60 Technical
Reference Guide.
❏
Using a Web browser
1. Start Windows Internet Explorer (or your Web browser).
2. Input the IP address of the TM-P60 in the browser address bar and press
Enter (Example: http://192.168.192.168 [default]).
3. The browser displays a dialog box requesting a user name and password.
Click OK without entering any user name or password. (If you have changed
the user name and password, you need to input them.)
4. You can modify the parameters by following the menus. You must click
Submit to send the change to the printer and then click Reset to make the
submission effective on each Web page. If you change the IP address, SSID,
etc., you have to change the setting of the host PC and AP to match the
printer's setting.
10 TM-P60 User's Manual (IEEE802.11b)