Belt Clip; Cleaning The Thermal Head - Seiko Epson TM-P60 Manuel D'utilisation

Masquer les pouces Voir aussi pour TM-P60:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
Align the left edge of the roll paper with the edge of the cover. See ➂ in
5.
illustration
6.
Close the roll paper cover and tear off the paper with the manual cutter.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
Remaining battery charge is not adequate
Host disconnection
Roll paper end
Error
Transmission of status information

Belt Clip

See illustration
You can hang the printer on your belt using the belt clip attached to the back of the
printer. If you want to hang the printer on your neck, you can use the neck strap
provided as an option.
Troubleshooting
No lights on the control panel
Check that the battery is installed.
ERROR LED is flashing or on
The printer temperature may be too high. The printer resumes printing
automatically when the temperature returns to normal.
Make sure that the roll paper cover is properly closed.
Make sure that roll paper is installed.
When the printer power is on, if the ERROR LED and the BATT. LED are on,
the remaining battery charge is not enough for printer operation. The battery
must be fully charged.
When the battery is being charged, if the ERROR LED is on, an abnormality
has occurred. The battery must be replaced with a new one.
Turn off the power, wait several seconds, and then turn it on again. If the
error remains, contact a qualified service person.

Cleaning the Thermal Head

CAUTION:
After printing, the thermal head can be very hot. Be careful not to touch it and
to let it cool before you clean it. Do not damage the thermal head by touching
it with your fingers or any hard object.
Turn off the printer, open the paper roll cover, and clean the thermal elements of
the thermal head with a cotton swab moistened with an alcohol solvent (ethanol,
methanol, or IPA). See illustration
EPSON recommends cleaning the thermal head periodically (generally every
3 months) to maintain print quality.
D
.
E
.
F
.
TM-P60 User's Manual (IEEE802.11b) 9
English

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

M196a

Table des Matières